Windows subnet ping

The We pipe that into a foreach-object loop. This will repeat whatever is inside the loop. In this case times. Inside the loop, we use the Test-Connection command and set up the -ComputerName flag. Next, we set the subnet that we want to explore. The next flag is the -count flag. This is how many times you want to try to connect to the device.

It would be great if you didn't need a batch file, but i understand if this is impossible. By using -n 1 you are asking for only 1 packet to be sent to each computer instead of the usual 4 packets. The above command will ping all IP Addresses on the Although it will take quite a bit longer to complete, you can also resolve the IP Addresses to HOST names by simply adding -a to the ping command. This is from Here. I know this is a late response, but a neat way of doing this is to ping the broadcast address which populates your local arp cache.

This can then be shown by running arp -a which will list all the addresses in you local arp table. This post asks the same question, but for linux - you may find it helpful.

Send a ping to each IP on a subnet. It is available for the windows platform on the nmap. All you are wanting to do is to see if computers are connected to the network and to gather their IP addresses.

I have found this tool very helpful when trying to see what IPs are being used that are not located inside of my DHCP. Some things seem appeared to have changed in batch scripts on Windows 8, and the solution above by DGG now causes the Command Prompt to crash. Stack Overflow for Teams — Collaborate and share knowledge with a private group.

Create a free Team What is Teams? Collectives on Stack Overflow. Learn more. Ping all addresses in network, windows Ask Question. This browser is no longer supported. Download Microsoft Edge More info.

Contents Exit focus mode. Is this page helpful? Please rate your experience Yes No. Any additional feedback? Submit and view feedback for This product This page. View all page feedback. In this article. Specifies ping continue sending echo Request messages to the destination until interrupted. Specifies reverse name resolution be performed on the destination IP address. If this is successful, ping displays the corresponding host name. Press OK twice. We can now test this configuration again by trying to ping Windows 10 from our local PC.

Rather than timing out it should now show replies, with information about the time to respond, TTL, bytes and finally a summary of packet loss and round-trip times.